Appendix 1 - Diagrams: Pc Cable, Torque Transducer Connectors And I/O Connector - Georges Renault DELTA4000 Manual Operario

6159938010-07
English
16 / 200

Appendix 1 - Diagrams: PC cable, torque transducer connectors and I/O connector

Diagram of PC cable number 6159170470
Connector SubD 9 point
contact socket
PC side
1
2
3
4
1
6
2
7
3
5
8
4
9
5
6
7
8
9
Connecting a Bar code reader
A bar code reader can also be connected to the PC connector.
The type of cable depends on the bar code reader (on the unit side, reception is connected to contact no. 2 and transmission
is connected to contact no. 3).
The contact no. 9 of the PC connector can be used to supply a bar code reader with 5V 100mA max. power.
It is recommended to disconnect the bar code reader before recharging the battery.
Note: On the former units which do not have this 5V power supply, the 7.2V battery voltage can be obtained using contact
no. 5 of the "Input / Output" connector (contact 4 = 0V).
Input / Output connector
Inputs:
pin no. 9 : Reset / Save: the measurement is saved and the display is reset (same as
pin no. 1 : Reset / No save: The display is reset and the measurement is not saved.
Inputs enabled on level between 5 and 24V (with respect to the earthing - pin no. 4).
Input impedance: 560 KOhm.
Outputs:
Open collector type with recovery diode (100mA per output as a maximum)
- pin no. 12: min. report
- pin no. 13: Accept report
- pin no. 14: max. report
- pin no. 15: target torque processed by an external device
- pin no. 11: common of recovery diodes for inductive loads
- pin no. 8:
- pin no. 2:
- pin no. 4
(white)
DCD
(brown)
RD
(blue)
TD
(red)
DTR
(black)
GND
DSR
RTS
CTS
internal 15V power supply that can be used to supply the outputs (50mA as a
maximum)
analog torque (0-10V, maximum load: 10 kOhm)
earthing
DELTA4000/5000/4D/5D
Connector SubD 9 point
contact socket
controller side
DTR
TD
RD
DCD
GND
DSR
RTS
CTS
4
3
2
1
1
6
2
7
3
5
8
4
9
5
6
7
8
9
¢
key).