Appendix 2 - Standard Printing Format For The Measurements; Appendix 3 - "Curve" Format - Georges Renault DELTA4000 Manual Operario

6159938010-07
English
18 / 200

Appendix 2 - Standard printing format for the measurements

The standard format includes:
- a 4-line header (optional)
- N lines of measurements
- one footing line (optional)
Header:
GR MEASUREMENTS
Name of task
No. Date Time T (Nm)
(* Angle A for the DELTA5000/5D only)
Note:
When a measurement is not displayed, it is replaced by blanks.
Each line ends with the codes <CR> (0xD) and <LF> (0xA).
The measuring unit depends on the option selected by the operator.
Measurement line:
NNNN_DD/MM/YY_HH:MM:SS_CCCCCC_AAAAAAA_R
NNNN
DD/MM/YY
HH:MM:SS
TTTTT
AAAAAAA
R
_
Note:
When a measurement is not displayed, it is replaced by blanks.
Each line ends with the codes <CR> and <LF>.
Footer:
This line includes the page number.
DELTA torque Nm
XX,XXXXX_XX,XXX_XXXX,XX
DELTA torque Nm
XX,XXXXX_XX,XXX_XXXX,XX
A(°)*
measurement number
date (depends on the format selected by the user)
time (depends on the format selected by the user)
torque
angle (for the DELTA5000/5D only)
A (accept) or R (reject) report
corresponds to a blank

Appendix 3 - "Curve" format

Heading line (including the torque measuring unit).
x points of the curve.
Angle value (for the DELTA5000/5D)
Tabulation character (for the DELTA5000/5D)
Torque value.
Time value (in seconds).
DELTA4000/5000/4D/5D
DATE TIME
CR