Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
When ordering spare parts, specify the model of the sweeper,
registration number, reference number of the component in the
spare parts book and quantity.
Storing the sweeper
If the sweeper is not used for a number of days, protect exposed
parts (not protected by paint, surface treatment or plastic) with
protective rust prevention oils. If the sweeper is not to be used for
particularly long periods, you should also clean it thoroughly. After
performing these operations, seal the sweeper inside an opaque
black multilayer nylon bag together with a suitable drying agent
(silica gel).
Disposal
At the end of its useful life, you have to scrap and dispose of this
product by taking it to a local differentiated waste collection center in
conformity to law. Before scrapping, check the serial number plate
on the machine: if it has the symbol
regulated by EU Directive 2003/96 (Waste Electrical and Electronic
Equipment, WAEE). The user must inquire about the local electrical
and electronic waste collection system and follow its instructions.
Illegal disposal of this product with normal domestic waste can
seriously harm the environment and health and is subject to
administrative penalties.
Table of regular maintenance
OPERATION
Replace the belts
Check belt
tension
Check the
tightness of
screws and nuts
Check the
condition of the
brushes
Check the
condition of the
flaps
, it means that disposal is
X
X
X
X
X
Troubleshooting
The table below gives the most common problems which may arise
during normal use of the SWEEPER. These problems are easy to
resolve with operations classified as routine maintenance If the
problem is not present in the following table or cannot be eliminated
following the instructions here, contact an authorised service centre.
PROBLEM
CAUSE
The
centre
brush
Broken belt
does not turn
Brushes worn
The sweeper does
not clean well
Type of brushes
not
cleaning the type
of floor and dirt
present
The side brush does
Broken belt
not turn
Dust comes out of
Gas
the fan
ket wear
Brushes wear out
Brush pressure too
too fast
high
Dust is discharged
Flap rubber worn
during work
SOLUTION
Replace the belt
Check the state of wear
of the brushes and if
necessary replace
Change type of brush
suitable
for
with respect to those
mounted as standard
(OPTIONAL)
Replace the belt
Replace the gaskets
Adjust brushes
Replace flaps
Publicidad
Tabla de contenido
