Harsh Enclosure - Mettler Toledo IND780 Guia De Instalacion

3. Place the terminal through the cutout from the front and secure by fitting the backing plate over
2.3.2.

Harsh Enclosure

The harsh enclosure is made of stainless steel and designed to rest on a flat surface such as a
table or desk top, or to be mounted to a vertical surface with optional mounting brackets. In desktop
configuration, the front panel angle is approximately 70 degrees from vertical. In wall mount
configuration, the front panel is approximately 40 degrees from vertical, and reversible (angled up
or down).
64057253 | 14 | 08/2014
enclosure, one with the backing plate removed to show the gasket, the other with the backing
plate installed.
Figure 2-4: Gasket on Enclosure (left) and Backing Plate Installed (right)
the back of the terminal, then installing and tightening the eight nuts until secure. Figure 2-5
shows a side view of a panel installation.
Figure 2-5: Panel Mounting, Side View
METTLER TOLEDO IND780 Installation Guide
2-5