Powercell Mtx; Jumper Settings - Mettler Toledo IND780 Guia De Instalacion

2.7.3.

POWERCELL MTX

2.7.3.1.

Jumper Settings

Two jumpers on the POWERCELL MTX board are designed W1 and W2. If the application contains
more than 14 POWERCELLs, an external Power Supply (P/N 0917-0240) must be connected on
pins 9 and 10 of the board connector, and jumper W2 should be in the 24V position. Figure 2-45
shows the jumper's locations and settings. Table 2-9 describes the purpose of each setting.
2-28
METTLER TOLEDO IND780 Installation Guide
W2 (Pin 1)
W1
Figure 2-45: POWERCELL MTX Card Jumper Locations and Settings
Table 2-9: POWERCELL MTX Jumper Description
Jumper On Off
This jumper should be closed when a network terminating resistor is required
X
to be installed in the terminal. This resistor is almost always required.
W1
This jumper should be open when a network terminating resistor is not to be
X
installed in the terminal.
Pins
When 14 or fewer load cells are connected, internal power (12V) can be
1, 2
used, and the jumper should close pins 1 and 2.
W2
When more than 14 load cells are used, external power is necessary and the
2, 3
jumper should close pins 2 and 3.
Figure 2-44: POWERCELL MTX Option Board
Pin 1
Voltage and Terminating
Resistor Setting Jumpers
Description
64057253 | 14 | 08/2014