Marking Mounting Hole Position - Mettler Toledo IND780 Guia De Instalacion

2.3.3.1.

Marking Mounting Hole Position

Mark the position of the mounting holes on the vertical surface per the dimensions shown in Figure
2-11 in inches and [mm], or by holding the terminal up to the surface and marking through the
bracket holes.
Once the mounting hole positions are established, perform one of the following procedures,
depending on the type of wall surface.
CAUTION: When carrying out the following procedures, wear proper bodily protection, such as
approved safety goggles, ear protectors and gloves.
2-8
METTLER TOLEDO IND780 Installation Guide
Figure 2-10: Attaching the Wall-Mounting Brackets
The hardware to mount the terminal to the vertical surface is not included with the terminal – it must be
supplied locally. Ensure that the mounting hardware is capable of supporting the weight of the terminal,
which is approximately
11 lb (5 kg).
Figure 2-11: Mounting Hole Pattern
Brackets
64057253 | 14 | 08/2014