Mounting The Panel Protection; Assembly And Adjustment Of The Seat; Seat With Default Adjustment - TRAPP LT4217 Manual De Instrucciones

Mounting the panel protection

If your tractor does not come with protection of the
mounted panel, follow the instructions below:
1. Remove the hexagon screws that are in the guard;
2. Raise the engine hood and position the panel
shield as shown in Image 3;
3. Replace the hex bolts and tighten them;
4. Before giving the final tightening, adjust the
protection with the engine hood closing.
Image 3

Assembly and adjustment of the seat

The seat adjustment type is the default adjustment.
Default adjustment.
 
120

Seat with default adjustment

Remove the seat base screw and align the seat
 
grooves in the bracket (B). Afterwards, slide the
seat carefully onto the bracket by adjusting the
most suitable position, and secure the bolt (A).
a
A
b
B
Warning!
Before operating the tractor, make sure that the
seat is snug and secure in the securing brackets.
www.trapp.com.br