Publicidad
Idiomas disponibles
Idiomas disponibles
CLUTCH SET -UP PROCEDURE (cont'd)
STEP #4
Installer should carefully verify that there is 1/2" - 5/8" gap between clutch cover and release bearing, 1/8" of free travel
between yolk and wear pads (mechanical linkage only), and 1/2" - 9/16" gap between release bearing and clutch brake.
Figure 6
If Fiber Spacer is to be installed
after transmission, notch "V" as
shown in Schematic 1.
1/2"
-
5/8"
DIM B
1/8" (Mechanical Linkage Only)
5
Schematic 1
O.D. 2"
I.D. 1.5"
Fiber Spacer
1/2" - 9/16"
Publicidad
