Intended Use; Mounting And Setup; Mounting The Support Rod; Mounting The Stirrer On A Stand - Marienfeld R18 Manual De Instrucciones

04/2019

4. Intended use

The microprocessor controlled overhead stirrers R18 and R50 resp. R50 D are designed for
qualified use in laboratories. They are mainly used to stir liquids from aqueous to medium
viscosity. For correct use the instrument must be fixed to an appropriate stand.
To ensure maximum service life, observe the specified ambient conditions (temperature and
humidity) and ensure that the instrument is not exposed to a corrosive atmosphere.

5. Mounting and setup

5.1 Mounting of the support rod
Fasten the support rod (A) by screwing the two M5 screws (B) into the provided
●
threaded holes at the rear side of the panel.
Tighten the screws thoroughly using a suitable hexagon key.
●

5.2 Mounting the stirrer on a stand

Fasten the bosshead on the rod of the stand (C) at one end.
●
Insert the support rod at the other end of the bosshead (D)
●
Tighten the thumbscrew (E) until the support rod is securely fastened
●
Paul Marienfeld GmbH & Co. KG
Am Wöllerspfad 4
97922 Lauda-Königshofen, Germany
Tax number: 8028008501
VAT reg. no.: DE 811 479 105
Insert the support rod here (D) and tighten the
thumbscrew (E) until the support rod is securely
fastened.
Phone: +49 (0) 9343 6272-0 Deutsche Bank Würzburg
Fax: +49 (0) 9343 6272-25 IBAN: DE95 7907 0016 0130 0888 00
info@marienfeld-superior.com
SWIFT: DEUT DE MM 790
www.marienfeld-superior.com
Support rod (A)
M5 screws (B)
(C) Insert the stand rod here and
tighten the thumbscrew until the
stand rod is securely fastened.
Commercial Register Mannheim HRA 550306, personally liable
partner: Marienfeld-Verwaltungs-GmbH, 97922 Lauda-Königshofen
Commercial Register Mannheim HRB 560548, Managing Directors:
Gerd Marienfeld, Harry Marienfeld
19