Additional Safety Features; Putting On And Taking Off; Putting On The Helmet; Removing Off The Helmet - SCHUBERTH M1 Manual De Instrucciones

C. THE HELMET

11. ADDITIONAL SAFETY FEATURES

ANTI-ROLL-OFF-SYSTEM (A.R.O.S.)
SCHUBERTH's proprietary Anti-Roll-Off-System ensures that when the chin strap is closed
and properly configured
a) the helmet cannot twist off the head from the rear,
b) no contact can occur between the visor edge and
the chin or neck of the rider due when the head is
put at a sharp angle
c) contact between the helmet and the body is
reduced during an accident.
Reflective Areas
There are two reflecting areas to the left and right below the
visor lens. They are complemented by silver-coloured reflecting
appliqués on the neck padding to promote strong visibility
of the motorcycle rider in street traffic. In addition, the
SCHUBERTH script on the brow of the helmet are produced
using reflective foil.
Note:
Keep the reflective safety areas clean.
Note:
When using the helmet in France, additional reflective
safety stickers must be applied on the left and right of
the helmet at the brow and on the rear.
40
D. PUTTING ON AND TAKING OFF

1. PUTTING ON THE HELMET

1. Retract the sun visor within the helmet shell.
2. Open the chin strip.
3. Grasp the lower ends of the chin strap and
pull them apart.
4. The helmet should now pull easily over the head.
5. Close the chin straps, using the ratchet lash
to insert the chin strap piece by piece into the
clasp until it fits snugly.
6. Ensure that the chin strap is arranged beneath
the chin and sitting snugly.
2. REMOVING THE HELMET
1. Retract the sun visor within the helmet shell.
2. Open the chin strip.
3. Draw the ratchet lash out of the clasp.
4. Grasp the lower ends of the chin strap and
pull them apart.
5. The helmet should now pull easily off the head.
Tip:
To avoid scratching other objects onto which the helmet is set down, the chin straps
should be closed once it has been removed.
EN
41