Manoeuvring The Caravan; Coupling The Towing Vehicle; Deactivating The Go2; Disengaging The Go2 - GO2 RH3 Instrucciones De Uso

Manoeuvring the caravan

Before manoeuvring, release the parking brake and
remove the chocks.
The "Off" switch on the remote control (Figure 2 - 3)
can also be used as an "emergency stop switch". In
case of any problems, e.g. uncontrolled behaviour of the GO2,
press the "Off" switch immediately.
– Use the direction buttons (Figure 2 - 1/2/4/5/6/8) to move
the caravan in the required direction.
If you press opposite direction buttons simultaneously
(Figure 2 - 2/6 or 4/8), the caravan rotates around its own
axle in the respective direction.
– While moving (forward/backward), the driving direction can
be changed with the direction buttons (Figure 2 - 2/8 and
4/6).
When the buttons are released, or if the radio signal is
interrupted or becomes too weak, the caravan stops moving.
Radio equipment and other GO2 remote controls will not
activate your GO2.
After starting up, the GO2 moves at an even speed. Speed
increases slightly on downhill slopes and decreases on uphill
slopes.
System factors mean that the speed increases on slopes. You
can reduce the speed by stopping and restarting the caravan
several times.
– After manoeuvring, apply the parking brake first and/
or secure the caravan with chocks to prevent it from rolling
away, then deactivate the GO2.

Coupling the towing vehicle

The caravan must not be towed with the drive
rollers engaged.
The GO2 allows a caravan to be coupled to a towing vehicle
with millimetre accuracy. However, this requires care and a
degree of practice.
Following the operating instructions, move the caravan close
to the towing vehicle (apply parking brake and engage gear).
In order to position the caravan precisely, use the direction
buttons of the remote control until the caravan's coupling is
directly above the ball coupling on the towing vehicle. Then
couple the caravan to the vehicle by lowering the jockey
wheel in the usual manner.
Prepare the caravan for towing in the usual way.
Then disengage the GO2. Make sure that the towing vehicle
cannot roll away.
14 EN

Deactivating the GO2

Disengaging the GO2

Figure 9
– Attach the engagement lever to the toggle crank
(Figure 9 - 1).
– Turn the engagement lever in the direction of the arrow
(away from the vehicle wheel) (Figure 9 - 2) until the driver
roller engages securely in the end position. The position
indicator in the housing is now at "X" (Figure 10 - 1).
Figure 10
– Removing the engagement lever
Switching off the remote control (emergency
stop)
When you switch off the remote control, this
immediately stops all current processes (e.g. engaging
and manoeuvring). When it is switched on again, these
functions can be continued.
The remote control switches off after about 3 minutes if
no actions are performed.
– Press the button (Figure 2 - 3) on the remote control. The
LEDs go out.

Disconnecting the power supply

Each time you are finished using the GO2, interrupt the power
supply of the GO2 on the battery cut-out switch and remove
the key.
Keep the key of the battery cut-out switch in a safe place
away from children.
1
2
1