Safety Messages To Installers - Federal Signal 191XL Serie Manual De Instalación Y Mantenimiento

Safety Messages to Installers

It is important to follow all instructions shipped with this product.
This device is to be installed by a trained electrician who is
thoroughly familiar with the National Electrical Code and/or
Canadian Electrical Code and will follow the NEC and/or CEC
Guidelines as well as all local codes. This beacon should be
considered a part of the warning system and not the entire warning
system.
The selection of the mounting location for the beacon, its controls
and the routing of the wiring are to be accomplished under the
direction of the facilities engineer and the safety engineer. In
addition, listed below are some other important safety instructions
and precautions you should follow:
• Read and understand all instructions before installing or
operating this beacon.
• Do not connect this beacon to the system when power is on.
• Do not disconnect the beacon while circuit is live or unless the
area is known to be free of ignitable concentrations. Keep the
beacon tightly closed when in operation.
• After installation, make sure that all set screws and threaded
joints are properly tightened.
• Never alter the unit in any manner. Safety in hazardous
locations may be endangered if additional openings or other
alterations are made in units specifically designed for use in
these locations.
• To be an effective warning device, this product produces bright
beacon that can be hazardous to your eyesight when viewed at
a close range. Do not stare directly into this lighting product at
a close range or permanent damage to your eyesight may occur.
Installation and Service Instructions
Model 191XL Series LED Beacon
5