Wiring The Beacon - Federal Signal 191XL Serie Manual De Instalación Y Mantenimiento

Installation and Service Instructions

Wiring the Beacon

SHOCK HAZARD: To avoid electrical shock hazards, do not
connect wires while power is applied.
EXPLOSION HAZARD: Do not disconnect the beacon while
the circuit is live or unless the area is known to be free of
ignitable concentrations. Keep the beacon tightly closed when in
operation.
Wiring must comply with the National Electrical Code or Canadian
Electrical Code and the local authority having jurisdiction.
The Model 191XL Series LED Beacon should be installed per the
NEC or CEC, STATE and LOCAL CODES. Alternate installation
locations and/or orientations should only be performed with the
approval of the authority having jurisdiction. In addition, the unit
can be mounted using an optional ceiling mount or optional wall
mount.
SHOCK HAZARD: To avoid electrical shock hazards, do not
connect wires while power is applied.
NOTE: 191XL Series beacons that are 24 V models are designed
to operate on AC and DC supply voltages. The 120-240 Vac model
is designed to operate 100 Vac to 265 Vac at 50/60 Hz. See Table 1
on page 7 for electrical ratings.
REVERSE POLARITY/MISWIRING: The 191XL Series is not
polarity sensitive, but MAY BE DAMAGED by incorrect electrical
hookup. Damage will result if the voltage rating of the particular
model is exceeded.
Model 191XL Series LED Beacon
12