Gas Connection; Gas Supply Transformation - Fimar FME Uso Y Mantenimiento

PIZZA OVENS
(GAS POWERED)

GAS CONNECTION

All the gas connection, transformation and pressure control operations must be per-
formed by authorised personnel who must have specific technical skills and special
abilities in the specific sector. This also applies for all extraordinary maintenance oper-
ations such as lubrication and/or faucet replacement and thermocouple or burner
replacement.
Equip the appliance gas supply tube with a faucet to be able to cut of gas supply in the
event of need.
The faucet (not supplied with the appliance) must be installed in a visible and accessi-
ble position in order to easily identify its operating status (open or closed).

GAS SUPPLY TRANSFORMATION

The appliance is marketed with indications of the gas mains used by the manufacturer
for inspections.
If the gas mains do not correspond to the one used for inspection, before connecting
GB
the gas mains, the installation technician must "transform" the appliance and indicate
the type of gas in use on the plate.
Important
After "transforming" the appliance to the gas mains in use, make sure there are no
gas leaks or operating defects, test the appliance and indicate the type of gas in use
on the identification plate.
To "transform" and adapt the appliance to the gas mains in use, close the gas supply
faucet and perform the listed operations.
– burner nozzle replacement
– pilot flame nozzle replacement
– primary burner air adjustment.
– Heat power adjustment to minimum
- 27 - English language