Optional Steam Operation - Mi-T-M HHB Serie Manual Del Usuario

OPERATING INSTRUCTIONS
TIME DELAY SHUTDOWN OR AUTO START/STOP CHOICE (HHS ONLY):
This unit is equipped with Time Delay Shutdown and Auto Start/Stop. To
switch between Auto Start/Stop and Time Delay Shutdown, see below.
From Wiring Diagram
BLK / 104
Time Delay Shutdown
Auto Start/Stop
OPTIONAL STEAM OPERATION (HHS ONLY):
250° STEAM OPTION (HX-0172, HX-0174 AND HX-0176):
1. Install Steam Nozzle.
2. Follow steps 1-9 of Start-up / Cold-Water Operation.
3. Recheck the system for water leaks and fuel leaks. If a leak is found, TURN
UNIT OFF IMMEDIATELY!
4. Turn adjustable thermostat clockwise to maximum setting. If a lower
thermostat setting is desired, it is normal for the burner to cycle (fire
intermittently) while spraying. (Note: Adjustable thermostat is a high limit
device and does not regulate temperature.)
NOTE: Upon initial start-up, water will begin turning hot in approximately 20
seconds and will reach steam temperature in approximately 5 minutes
providing the trigger remains squeezed. The burner will not fire when
the trigger is released.
At this point, the unit will operate as a steam pressure washer. Be extremely
cautious when adjusting the pressure and controlling the trigger gun/dual lance
assembly to avoid the possibility of burns.
Operator's Manual
WARNING
RISK OF BURN!
THE WATER TEMPERATURE
COULD BECOME VERY HOT
DURING HOT WATER/STEAM
OPERATION. BE CAUTIOUS
WHEN ADJUSTING PRESSURE
OR CONTROLLING THE TRIGGER
GUN/LANCE ASSEMBLY.
15