Important Safety Instructions; Risk Of Electric Shock Or Electrocution - Mi-T-M HHB Serie Manual Del Usuario

WARNING: When using this product, basic precautions should always be observed, including the following:
READ ALL SAFETY WARNINGS BEFORE USING PRESSURE WASHER
HAZARD
RISK OF
ELECTRIC SHOCK
OR
ELECTROCUTION
4

IMPORTANT SAFETY INSTRUCTIONS

POTENTIAL CONSEQUENCE
Serious injury or death could occur if
the pressure washer is not properly
grounded. Your pressure washer
is powered by electricity and may
cause electric shock or electrocution
if not used properly.
Electrical shock may occur from
electrical cord.
Electrical shock may occur if
pressure washer is not operated
properly.
Serious injury or death may occur if
electrical repairs are attempted by
unqualified persons.
PREVENTION
This product must be grounded. Make sure
the pressure washer is equipped with a GFCI
built into the power supply cord. If this is not
available, the pressure washer must be plugged
into a receptacle that is protected by a GFCI.
Disconnect when not in use.
If your unit is equipped with a GFCI, DO
NOT drop the GFCI as damage could
result. If the GFCI is accidentally dropped,
be certain to test the GFCI before using
to ensure it is working properly. (Follow
instructions on GFCI for test procedures.)
Always be certain the unit is receiving proper
voltage. Before plugging the unit into a
compatible power source, be certain the
switch is in the "OFF" position. Disconnect
when not in use.
Do not modify the electrical plug. If it will not
fit the outlet, have a proper outlet installed by
a qualified electrician. Do not use any type
of adapter.
Check power cord for signs of crushing, cutting
or heat damage. If replacement of plug or
cord is needed, use only identical replacement
parts.
Do not use extension cords with this pressure
washer.
Keep all connections dry and off the ground.
Do not allow electrical cords to lay in water or
in such a position where water could come
in contact with them. Do not touch plug with
wet hands.
Do not pull on the electrical cord to disconnect
from the outlet.
DO NOT direct spray on or into electrical
installations of any kind! This includes electrical
outlets, light bulbs, fuse boxes, transformers,
the unit itself, etc.
DO NOT allow metal components of the
pressure washer to come in contact with live
electrical components.
Never operate the pressure washer with safety
guards/covers removed or damaged.
Any electrical wiring or repairs performed on this
pressure washer should be done by Authorized
Service Personnel in accordance with National
and Local electrical codes.
Before opening any electrical enclosure, always
shut off the pressure washer, relieve pressure
and unplug the pressure washer from the power
source. Allow the pressure washer to cool
down. Never assume the pressure washer is
safe to work on just because it is not operating.
It could restart at any time! Service in a clean,
dry, flat area.
Operator's Manual