Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: check that the lock catches without creating friction and regulate the
GB
parameter
fend
•
(end force thrust on striking)= this is the force that the motors exercise in
closing once the limit stop strikers are reached. This is stated in percentages
compared with the maximum force that the motors themselves can exercise. The
default value set by Stagnoli is 30 and it can be regulated from 20 to 70.
WARNING: regulate
The regulation of this parameter can infl uence the time and force with which the
gate works in the fi nal phase of the stroke.
Functions
ca
•
(automatic closing)= automatic closing of the gate after it has opened fully.
ca=0
function not enabled.
ca=1
function enabled.
Set the
ning to the start of automatic closing. N.B: If
activated while the leaves are opening, will stop the gate and load the
for automatic closing.
ba
•
(impulse block during opening)= the control board ignores the START impul-
ses during the opening phase.
ba=0
function not enabled.
ba=1
function enabled.
bp
•
(blocks impulses during pause)= the control board ignores the START impul-
ses during the pause between opening and automatic closing (
command received during the pause between opening and automatic closing
recharges the
bp=0
function not enabled.
bp=1
function enabled.
These functions allow the gate not to block or reverse the stroke due to other START
commands, in condominium use for example.
cr
•
(rapid closing)= if there is a passage through the photocells during the ope-
ning phase or with the gate open, the regulation time
ater than 3 secs) is automatically reduced to 3 secs.
cr=0
function not enabled.
cr=1
function enabled.
2p
•
(open/close operation)=
movement of the gate changes direction (OPENING - CLOSING).
2p=0
function not enabled. the gate movement sequence becomes OPENING -
CLOSING (
pl
•
(prefl ashing)= after the START signal, the fl asher or courtesy light activates for
two seconds before the opening or closing phase begins.
pl=0
function not enabled.
pl=1
function enabled.
26
tser
accordingly.
fend
ttca
regulation to customise the time that must pass from the end of ope-
ttca
time.
ttca
) - CLOSING - STOP.
with a low value should the gate structure be very light.
2p=1
function enabled: at each START impulse, the
ca=1
2p=0
and
, a START command,
ca=1
ttca
(if activated and gre-
ttca
time
). Each START
Publicidad
