Jump Start - miniJOULE Island MJI-1500-01 Manual De Instrucciones

2.Jump Start:

Jump start in this system could start 12V vehicle and boat battery, please use cable we
supplied or the standard cables in the market.
WARNING:
It may cause the phenomenon of sparking discharge.
Jump starting a battery can crank huge surge current through the system, which
is the possibility to cause a fire.
WARNING: SHOCK HAZARD
Connect only in the following order and make sure the polarity is correct. The
battery's positive terminal is identified as being larger in diameter than the
negative terminal. In most vehicles it has a red wire connected to it, Do not
proceed until you are sure you have identified the positive terminal.
Jump right in by reading any of the following steps:
1) Make sure the vehicle/boat is in park and turned off.
2) Make sure all loads are unplugged, all the input power are unplugged.
3) Study all battery manufacturers' specific precautions.
4) Clean the oil spot on the terminals before connecting. Be careful to keep corrosion
from coming into contact with eyes.
5) Locate the system as far away from battery as the cable permit. Never allow clamps
to touch each other or other conducting parts.
6) Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a
larger diameter post than NEGATIVE (NEG, N, -)post
7) Connect POSITIVE (RED) clamp to POSITIVE (POS, P, +) ungrounded post of
battery. Do not connect clamp to carburetor, fuel lines or sheet metalbody parts.
8) Connect the cable (RED) to the jump start terminal (RED)
9) Connect NEGATIVE (BLACK) clamp to vehicle chassis or engine block away from
battery. Do not connect clamp to carburetor, fuel lines or sheet metal body parts.
10) Connect the cable (BLACK) to the jump start terminal (BLACK).
11) Start the engine.
12) If the engine could not be started, please disconnect the cables according to the step
(6) to step (11). Make sure there is no block for connection, and then reconnect the
cables and clamps according to the step (6) to step (11).
13) When the engine is started, it could charge the battery of our system for 5 minutes.
When finishing the charging, disconnect and remove the cables and clamps from the
step (11) to step (6).
3-4