miniJOULE Island MJI-1500-01 Manual De Instrucciones página 30

remove source from ground. Contact with any part of a grounded battery can
result in electrical shock.The likelihood of such shock can be reduced if such
grounds are removed during installation and maintenance
What's required for install:
Phillips Screwdriver #2
Small Slot Screwdriver
InsulatingTape
The replacement steps of the battery are asfollows:
1) Screw Off the four screws and open the upper cover.
2) Remove the fixed bar of the battery
3) Remove the connection of the POSITIVE (RED)
cable with the battery, wrap the lug of the cable
with insulating tape.
4) Remove the connection of the NEGATIVE
(BLACK) cable with the battery, wrap the
lug of the cable with insulating tape.
5)Take out the battery.
6) Put into the new battery and make it be in right
position. If the new battery is smaller than
previous one, please place it in the center position.
Keep the gravity balance of the system is easy for
you to pull.
7) Make sure the polarity to connect is correct.
8) Unwrap POSITIVE (RED) lug, connect the cables
to the POSITIVE (RED) terminal of the battery,
screw it up.
9) Unwrap NEGATIVE (BLACK) lug,connect the
cables to the NEGATIVE (BLACK) terminal of
the battery, screw it up.
10) Put back the fixed bar and screw it up.
11) Make sure the battery is fixed and the connection
is correct again.
12) Put back the upper cover, and screw it up.
Figure 6-1: Replacement of the Battery
6-2
Screw
Fixed Bar
173 mm
Battery
Positive (Red)
Battery
Negative
(Black)
330 mm
212 mm