Technical Characteristics; Radio Receiver - Nice Road400 Instrucciones Y Advertencias Para La Instalación Y El Uso

In order to improve its products, Nice S.p.a. reserves the right to modify the technical characteristics of its products at any time without prior notice. In any case, the
manufacturer guarantees their functionality and intended use. All the technical characteristics refer to a room temperature of 20°C (±5°C).
Type
Pinion
Peak thrust
Nominal torque
Idling speed
Nominal torque speed
Maximum frequency of
operating cycles
Maximum continuous operating
time
Operating limits
Road400 Power supply
Road400/V1 Power supply
Max. absorbed power
Insulation class
Flashing light output
STOP input
STEP BY STEP input
Radio AERIAL Input

Radio receiver

Programmable functions
Recognition functions
Operating temperature
Use in acid, saline
or potentially explosive
atmosphere
Protection class
Dimensions and weight
Type
Frequency
Coding
Transmitter compatibility (1)
Transmitters memorized
Input impedance
Sensitivity
Range of the transmitters
Outputs
Operating temperature
Note 1 – the first transmitter introduced also determines the type of transmitters that can be introduced afterwards.
12 – English

TECHNICAL CHARACTERISTICS

Road400
Electromechanical gearmotor for the automatic movement of residential sliding gates including electronic
control unit.
Z: 15; Module: 4; Pitch: 12.5 mm; Pitch diameter: 60mm
12 Nm; corresponds to the ability to start a leaf with a static friction of max. 400 N moving
5 Nm; corresponds to the ability to keep a leaf with a dynamic friction of max. 167 N moving
0.25 m/s; the control unit allows 2 speeds to be programmed, equal to: 0.13 m/s or 0.25 m/s
0.16 m/s
50 cycles per day (the control unit allows up to the maximum described in tables 1 and 2)
9 minutes (the control unit limits the continuous operation up to the maximum described in tables 1 and 2)
In general, Road400 is suitable for the automation of gates featuring leaves up to 5 m wide and weighing up to
200 kg, as shown in Tables 1 and 2
230Vac (+10% +15%) 50/60Hz
120Vac (+10% +15%) 50/60Hz
210 W (1,1 A)
1 (a safety grounding system is required)
For 1 MLBT flashing light (12V, 21 W lamp)
For normally open contacts, for 8.2KΩ constant resistance, or normally closed contacts; with self-recognition
(any variation from the memorized status causes the 'STOP' command)
For normally open contacts (the closing of the contact causes the "STEP-BY-STEP" command)
52 ohm for RG58 or similar type of cable
Incorporated
2 ON-OFF functions and 3 adjustable functions (see tables 12 and 14)
Recognition of the type of "STOP" device (Normally Open or Normally Closed contact or 8.2KΩ resistance)
Recognition of the length of the gate and calculation of the slowdown and partial opening points
-20°C ÷ 50°C
No
IP 44
330 x 195 h 277; 8 kg
Radio receiver
4 channel transmitter for incorporated radio command
433.92MHz
Digital fixed code with 12 Bit code, FLO type
Digital Rolling code with 52 Bit code, FLOR type
Digital Rolling code with 64 Bit code, SMILO type
FLO1R-S - FLO2R-S - FLO4R-S; FLO1RE - FLO2RE - FLO4RE; INTI1 INTI2; ON1E - ON2E - ON4E - ON9E;
VERY VR; FLO1 - FLO2 - FLO 4 - VERY VE; SM2 - SM4
Up to 160 if memorized in mode I
52Ω
better than 0.5µV
From 100 to 150 m. The range can vary if there are obstacles or electromagnetic disturbances,
and is affected by the position of the receiving aerial
For commands as of table 4 and 5
-20°C ÷ 55°C