Remberg DIS2 Plus Manual De Instrucciones página 36

175 Reception Timeout

Defines the maximum wait time (after sending a query to the slave) before reception is canceled due
to a timeout.
When this happens, the lost packet counter will be increased.
10..1000 ms.
Default
176 Number of Errors

Defines the maximum number of allowed subsequent faults (reception timeouts, CRC errors ) before
the slave status is notified as offline.
Any successfull communication will reset the fault counter for off-line management to zero.
Setting this parameter to 0 will prevent the error notification
0..100. : 10.
Default
177÷185 Reserved Parameters - Group L
Reserved parameters - Group L.
11.m
GROUP M -

186 Timer 1
 
Enables timer 1
Disabled (
diSab.
Enabled
Enab.
Enabled and active at start
En.StA.
187 Time Base Timer 1
 
Selects the time base used by timer 1
minutes.seconds (
mm.SS
hours.minutes
hh.MM
188 Action Timer 1
 
Selects the type of action performed by timer 1 when connected to an alarm
Start. Active during timer counting (
Start
End. Active at timer expiry
End
Warning. Active 5" before the timer expiry
WArn.
189 Timer 2

Enables timer 2
Disabled (
diSab.
Enabled
Enab.
Enabled and active at start
En.StA.
190 Time Base Timer 2

Selects the time base used by timer 2
minutes.seconds (
mm.SS
hours.minutes
hh.MM
191 Action Timer 2

Selects the type of action performed by timer 2 when connected to an alarm
Start. Active during timer counting (
Start
End. Active at timer expiry.
End
Warning. Active 5" before the timer expiry.
WArn.
192 Timers Sequence

Select the correlation between the two timers.
Singles. Timers work independently (
SinGL .
Sequential. When timer 1 expires, timer 2 starts.
SeQue .
Loop. When a timer expires, another one starts.
LooP
193÷197 Reserved Parameters - Group M
Reserved parameters - Group M
36
: 100 ms.
- Timer
)
Default
)
Default
)
Default
)
Default
)
Default
)
Default
)
Default