Installing And Connecting Flashing Light Mod. Mf - moovo XW4 Instrucciones Y Advertencias Para La Instalación Y El Uso

05. Fig. 26:
a) Remove the power terminal board from its seat to enable loosen-
ing of the three terminal screws.
b) Proceed with connection of the cable wires, observing the sym-
bols on the terminal board and refit the latter in its seat.
c) Then tighten the cable clamp to secure the cable to the gearmo-
tor.
26
CAUTION! – never assemble the product in a position other
than those specified.
6.3 – INSTALLING AND CONNECTING
FLASHING LIGHT MODEL MF
This flashing device indicates execution of each manoeuvre. It is also con-
nected to the diagnostics system of the control unit and in the event of
malfunctions signals the type of problem by means of a pre-set sequence
of flashes (see paragraph "What to do if...").
To install and connect the flashing light proceed as follows:
01. Fig. 27:
Extract one of the two transparent covers, turning it anti-clockwise
and set aside.
27
02. Fig. 28:
Use two fingers and at the same time press the two tabs at the bot-
tom and use the other hand to remove the external cap of the flash-
ing light.
28
03. Fig. 29:
Drill the marked sections on the base of the flashing light for fixture
of the screws and routing of the cables.
29
English – 15