Installing And Connecting Keypad Mod. Mk - moovo XW4 Instrucciones Y Advertencias Para La Instalación Y El Uso

6.5 – INSTALLING AND CONNECTING
KEYPAD model MK
The control keypad is a wall-mounted device used for control of the
automation via a Bus connection. Up to 4 keypads can be connected in
a single system and the device can be programmed to operate in two
modes: Traditional mode (each key performs a specifically assigned func-
tion – factory set) and safety mode (to activate a manoeuvre, a secret key
sequence must be entered, as set by the user).
The keypad is backlit for poorly lit conditions.
To install and connect the keypad proceed as follows:
01. Fig. 42:
Remove the keypad cover by pushing down one side as shown in
the figure.
42
02. Fig. 43:
Using a screwdriver, open and detach the base of the keypad.
43
03. Fig. 44:
a) Drill a hole on the pre-cut section on the base for routing the con-
nection cables.
b) Fix the keypad base to the wall with the relative screws, routing
the cables through the prepared hole.
44
04. Fig. 45:
a) Connect the cable wires to the respective terminals.
b) Insert the cable connector in the male connector at the rear of the
keypad.
45
05. Fig. 46:
Refit the cover, ensuring that the serrated section engages with that
of the keypad base.
46
06. Fig. 47:
Fix the keypad cover to the base by means of the screw supplied.
Lastly refit the screw cover cap as shown in the figure.
47
English – 19