Step 7: Connect The Power Cord/Battery Charger - Circadiance Smart Monitor 2 Guía De Los Padres

Use of the third (green - RL) electrode and lead wire is normally not required, but may help reduce EMI interference.
Place the green third electrode along the outside of baby's upper thigh. (Not on the inside of the thigh, the inside can
cause discomfort).
Do not use oils, lotion, or powder on the area of skin that the electrodes will be placed.

Step 7: Connect the Power Cord/Battery Charger.

•
Insert the round connector of the power cord/battery
charger into the socket on the back panel of the
SmartMonitor 2 (see illustration).
•
Line up the notch on the connector.
•
Push until the connector is fully inserted.
•
Plug the power cord/battery charger into a power
outlet. The green charge light on the monitor will now
come on.
When the SmartMonitor 2 is not being used
portably, keep the power cord/battery charger connected
and plugged into an AC outlet at all times. Insure that the
AC outlet has been installed to conform to the National
Electrical Code (NEC) i.e., a licensed electrician. The
batteries cannot be overcharged. The green charger light
stays on as long as the charger is connected.
The Power Cord Connector must be plugged into
the SmartMonitor 2 DC Power Input as shown in the
illustration to the right. The Power Cord Connector can
only be inserted as shown to the right.
Do NOT use device if power cord or plug is
damaged. Contact your dealer.
Setting Up the SmartMonitor 2
24