Modem Auto Answer In Communications Mode - Circadiance Smart Monitor 2 Guía De Los Padres

If there is an emergency and access to the telephone is
required while modem is in use, remove phone cord
from modem slot and use a working phone.
•
Plug the telephone wire into the modem connector on the
back of the SmartMonitor 2 (see illustration).
•
Plug the other end of the phone wire into the wall phone
jack.
•
The SmartMonitor 2 will continue to monitor your baby
during download. All alarms are functional.
The monitor will continue calling every 30 minutes, for 4 hours, until it connects with the computer. If no connection is
made, the monitor will try again the next day at the pre-selected time. For example, when the modem is programmed
to call at 7am but fails to make a connection after 8 attempts it will stop trying. The next day at 7am it will try again.
This will continue until a connection is made.

Modem Auto Answer in Communications Mode

1. Connect a phone cord from the wall jack to the modem connector on the back of the SmartMonitor 2.
2. To allow the SmartMonitor 2 to work with the modem, place the monitor in Communications Mode:
•
Press and hold the blue RESET button.
•
Press and release the POWER button.
•
Wait until the monitor alarms. Now release the RESET button.
•
Briefly press and release the RESET button again.
•
The SmartMonitor 2 beeps every 10 seconds whenever it is in the Communications Mode. This is a reminder that the
SmartMonitor 2 is powered on for working with the computer, memory card, or modem, but NOT for monitoring the
infant.
Do not connect the infant to the SmartMonitor 2 when in the Communications Mode, the apnea and heart rate
alarms are not operational in this mode.
Transferring SmartMonitor Information
42