Wheel Installation - Marzocchi 320 LCR Manual De Instrucciones

3.3 Wheel installation

Wheel
Model
Compatibility
320 29" 29"
320 27,5" 27,5"
350 27,5"
SLOPE CR 26"
DIRT JUMPER 26"
380 26" / 27,5"
Table 5 - Maximum tire dimension
After installation, you must verify that the distance between the
infl ated tire and the lower part of the lower crown is at least four (4)
mm when the fork legs are fully compressed.
Before every use you must verify that:
• The tire turns freely;
• The tire does not make any contact with the arch or the brake
system.
L
L max D max
65 mm 750 mm
65 mm 710 mm
65 mm 724 mm
65 mm 692 mm
60 mm 684 mm
75 mm 712 mm
68 mm 724 mm
3.4 Wheel axle securing system
The wheel securing system on the fork monolite can be:
• 9mm QR,
• QR15 or QR20 quick release axle,
• ø20mm through axle.
Model
320
350
SLOPE CR
DIRT JUMPER
380
Table 6 - Wheel securing systems
3.4.1 - 9mm QR fork: wheel installation
DIRT JUMPER
Install the wheel in compliance with the wheel manufacturer's
instructions. For correct fork function after installing the wheel,
you will need to:
• Check the fork-wheel alignment by fully compressing the fork
a few times. The wheel should not make contact with, or come
close to any portion of the fork.
• Lift the front of the bicycle, and spin the wheel a few times to verify
correct alignment and spacing with the disk brake or the V-Brake
brake pads. Check the owner's manual of the brake system for
the proper specifi cations.
21
Wheel Axle
QR15
QR15
QR20
9QR - ø20mm
ø20mm