Arc Test - Promax PROLITE-40 Manual De Instrucciones

10.- Press to exit menu in turn.
NOTE:
1.- Press "AUTO" to modify step-size among "1", "10", "100" under two class
menu.
2.- You can only modify arc program No.6~No.100, but can refer to program
No.1~No.5.
7.3

Arc test

The field conditions (such as fiber, altitude, climate, electrode status, etc.) are
influential to splice loss. To get low loss, PL-40 provides test function to modify arc
current automatically. Operations are as follows:
1.- Press to enter the first class menu.
2.- Press or
3.- Press or
4.- Press or
5.- Press or
6.- Press or
7.- Press or
8.- Press to enter program parameter menu.
9.- Check whether fusion parameter is reasonable (consult program No.1~No.5.
fusion current's range is 10~16mA). Following methods can modify current
parameter:
a) Press
b) Press
parameter.
c) After confirming, press
d) Press
Page 30
to make cursor point to "working mode".
to select the value of "working mode" to 1.
to make cursor point to "Fusion fiber".
to select the value of "Fusion fiber" to 1 or 2.
to make cursor point to "Fusion program".
to select needed arc program.
or to make cursor point to modifiable parameter.
or to increase or decrease the quantity of selected
to save arc parameter.
to exit menu in turn.
USER'S MANUAL. PROLITE-40
02-2011