Heating Time; Setting End-Surface - Promax PROLITE-40 Manual De Instrucciones

Menu
Heat time Setup heat
time of heater on the
panel
Tension Test Setting
whether test tension
after splicing finish
Fusion program
Different fusion
program (200 kinds)
Working
Automation or manual
optionally
Heat time Setup heat
time of heater on the
panel
Tension Test Setting
whether test tension
after splicing finish
Fusion program
Different fusion
program (200 kinds)
5.1

Heating time

The setting range of heating time is 1-60s, step-size is 1S. If heat time is 4, actual
heat time is 4S. Press
will stop working if time is up. But if the temperature were the highest value, it would
keep the temperature regularly.
Remark: Press
5.2

Setting end-surface

Setting end-surface stands for the maximum cleaved angle under auto work
mode. Its setting range is 1~16, step-size is 0.5~8.0 °, it is 6 (3.0 ° ) usually. If the fiber's
cleaved angle is unqualified, the splicer will stop working and demand to do over the
end-face.
Page 20
Setting end-surface The maximum cleaved angle when it
works
Current deflection Basic value of arc current (do not change
it)
Fusion fiber SM fiber or MM fiber optionally
mode Maintenance Enter the next maintenance menu
Setting end-surface The maximum cleaved angle when it
works
Current deflection Basic value of arc current (do not change
it)
Fusion fiber SM fiber or MM fiber optionally
to turn on the light, then the heater begins to work; heater
to stop heating. Next heat time counts from zero.
Content
Table 5.-
USER'S MANUAL. PROLITE-40
02-2011