Threading The Machine; Bobbin Setting; Removing The Bobbin; Winding The Bobbin - Singer SE300 Manual De Instrucciones

T
HREADING THE

BOBBIN SETTING

this machine.
R B
EMOVING THE OBBIN
1. Pull the bobbin cover latch to the right and remove the
bobbin cover.
2. Lift up the bobbin from the machine.
S S T
ETTING POOL OF HREAD ON
1. Pull up the left end of spool pin and set the felt washer and
the spool of thread on spool pin so that the thread unrolls
from the front of the spool.
a. Reverse spool cap direction according to the size of
spool.
b. Use the small spool cap when you use cross wound
thread. Leave small opening between cap and spool as
illustrated.
c.
easily.
M
ACHINE
S P
POOL IN
17
W B
INDING THE OBBIN
1. Hold thread in both hands and hook thread to the guide
from front opening.
2. Bring thread to the right and pass it through the thread
guide from the back side. Pass thread under the bobbin
winding tension disk in a clockwise direction.
3. Insert thread through hole in bobbin and place the bobbin
on bobbin winder spindle.
4. Hold the end of the thread and push bobbin stopper to the
right. When the bobbin winding screen appears, press the
5. After the bobbin winds a few turns, stop the machine by
6. Cut the thread near the hole, as illustrated.
8. When the bobbin is wound fully, the bobbin stopper will
return to the left and stop winding automatically.
9. Remove the bobbin from the spindle and cut thread with
the thread cutter.