Connecting The Embroidery Unit; Embroidery Preparation; Attaching The Embroidery Foot; Messages At Start Up - Singer SE300 Manual De Instrucciones

by attaching the embroidery unit as follows.

CONNECTING THE EMBROIDERY UNIT

will open automatically when connecting the embroidery unit.
1. Turn the machine off before connecting the embroidery unit.
3. If needed, use the level adjusting feet so that the machine
and embroidery unit are even with one another.
T R E
O EMOVE THE MBROIDERY
1. To store the embroidery unit into the box, move the carriage
to park position by selecting Park Position in the Hoop
2. Turn off the machine.
and slide the unit to the left to remove it.
The cover of the socket closes automatically.

ATTACHING THE EMBROIDERY FOOT

1. Remove the presser foot and holder.
4. Tighten the presser foot screw securely.
U

MESSAGES AT START UP

NIT
When you turn the machine on, a series of messages will
appear on the screen.
a. If the needle is not in its highest position, this message
c. If presser foot is lowered, this message will appear. Raise
42
E P
MBROIDERY REPARATION
a
hand wheel toward you.
will appear. Turn the hand wheel toward you to raise the
When the messages a-c have cleared the screen, the
carriage will move to start point.
b
c
✓
✓
✓