Sm-Keypad Plus Set-Up Menus; Changing The Operating Mode - Control Techniques UNIDRIVE SP1201 Guía Rápida

Safety Product Mechanical
Information Information Installation

SM-Keypad Plus set-up menus

Pr
40.00 Zero parameter
40.01 Language select
40.02 Keypad software revision
40.03 Save configuration to flash
40.04 LCD contrast
40.05 SMARTCARD save/restore
40.06 Browsing filter
40.07 Keypad security code
40.08 Enable string DB upload
40.09 Hardware key security code
40.10 Keypad serial address
40.11 Keypad memory size
Pr
41.00 Zero parameter
41.01 ~
Browsing filter F01 to F20
41.20
41.21 Browsing filter exit parameter
5.6

Changing the operating mode

Changing the operating mode returns all parameters to their default value, including the
motor parameters. (Pr 0.49 Security status and Pr 0.34 User security code are not
affected by this procedure.)
Procedure
Use the following procedure only if a different operating mode is required:
1. Ensure the drive is not enabled, i.e. terminal 31 is open or Pr 6.15 is Off (0)
2. Enter either of the following values in Pr 0.00, as appropriate:
1253 (Europe, 50Hz AC supply frequency)
1254 (USA, 60Hz AC supply frequency)
3. Change the setting of Pr 0.48 as follows:
Pr 0.48 setting
The figures in the second column apply when serial communications are used.
Unidrive SP Short Form Guide
Issue Number: 1
Electrical Getting
Installation Started
Title
Same as every other zero parameter
English, Custom, French, German, Spanish, Italian
Firmware revision (e.g. 40102 is revision .04.01.02) (read-only)
Idle, Save, Restore, Defaults
xxx = Contrast Setting (0 = minimum, 31 = maximum)
Idle, Save, Restore (not implemented)
Normal, Filter
xxx = PIN number to enable/disable keypad security
Disable, Enable
Range = 0 to 999 to match drive security code
Needs to match drive serial address
4Mbit, 8Mbit (read-only)
Title
Same as every other zero parameter
smmpp = any parameter (slot, menu, parameter)
"Normal", "Filter"
1
2
3
Regen (See the Unidrive SP Regen User Guide for more
4
www.controltechniques.com
Running Advanced
Menu 0
the motor parameters
Description
Description
Operating mode
Open-loop
Closed-loop Vector
Closed-loop Servo
information about operating in this mode)
UL Listing
Diagnostics Appendix
Information
19