Manual Rpm Mode - Pentair Water Pool and Spa IntelliFlo VF Manual Del Usuario

14
Use Manual Mode to meaure and test the requirements of each fl ow-operated device in your pool system,
and record your results for later setup in the IntelliFlo's menus. See "Menus" on
instructions.
To operate IntelliFlo in manual mode:

Manual RPM Mode

1. Ensure that the green power LED is on.
2. Press the Manual button. Press the Start/Stop button. "MANUAL RPM" will appear in the top
left corner of the display, indicating that the pump is in Manual RPM Mode.
3. Use the Up and Down arrow buttons to view the screens below:
• POWER
• ACTUAL SPEED
• FLOW
the "Set FLOW" screen (See "To Change the Speed and Flow" on the following page.).
As long as the IntelliFlo is in MANUAL RPM Mode, the programmed, or "commanded",
fl ow —not the actual fl ow—will appear in the Flow screen. To view the actual fl ow,
switch from Manual RPM Mode to Manual Flow Mode (See "Manual Flow Mode" on the
following page.).
• Set SPEED
• Set FLOW
to change speed to manage the fl ow rate based on system changes
MANUAL RPM
15.W 15.W
POWER
RUNNING
IntelliFlo VF Installation and User's Guide
(Watts): Displays power to the motor shaft in continuous watts
(RPM): Displays pump speed in RPM
3
(m /h): Displays commanded fl ow. Will read "0" unless a value is programmed in
(RPM): Allows you to set IntelliFlo to run at a continuous pump speed
3
(m /h): Allows you to set IntelliFlo in Manual Flow Mode to allow the pump
® ®
12:15 MANUAL RPM 12:15
1000.RPM 1000.RPM
ACTUAL.SPEED
RUNNING
®
MANUAL RPM 12:15 MANUAL RPM
0 m³/h 0 m 1000.RPM 1000.RPM
FLOW Set SPEED
RUNNING RUNNING
page 21 for detailed
® ®
12:15 MANUAL RPM 12:15
12m³/ ³/h
Set FLOW
RUNNING