Pentair Water Pool and Spa IntelliFlo VF Manual Del Usuario página 37

Features Menu (Continued)
By entering the following parameters in the M.O. Flo setting, however, you can program IntelliFlo to
increase the fl ow rate from 4 m
pressure switch: Flow Rate=9m
12 m
4 m
Wave
Like the M.O. Flo feature, the Wave feature is designed to operate water features that require fl ow rates
of varying intensity. However, unlike M.O. Flo, the Wave feature directs IntelliFlo to transition smoothly
back and forth between minimum and maximum pump speed pararmeters within a specifi ed time period.
You set these maximum and minimum pump speeds, as well as the span of time, or period, in which
IntelliFlo will alternate between these speeds. Also unlike the M.O. Flo feature, which can operate only
during fi lter cycles set in Filter Mode, the Wave Feature must be linked to any of Features 1-9, and
operates only in conjunction with those features.
Example: You have installed laminar jets in your pool. In the Wave setting, you enter a maximum pump
speed of 2400 Rotations Per Minute (RPM), a minimum pump speed of 1000 RPM, and a
period of 10 seconds (:10), and you link the Wave Feature to Feature 3. IntelliFlo will increase
the pump speed to 2400 RPM , then smoothly decrease the pump speed to 1000 RPM within
the specifi ed ten second period. IntelliFlo will repeat this transition every 10 seconds for the
duration of Feature 3.
3
/h to 12 m
3
/h, Run Time=:03 (3 minutes), Interval Time=2 hours.
Flow
Run time
=3 min
3
/h
3
/h
Filter
Cycle
Pump Speed
2400 RPM
1000 RPM
Filter cycle
Feature 3
Start
3
/h for three minute intervals, every two hours, thus tripping the
Interval time
=2 hours
10 hours
:10 :20 :30 :40
Time
Filter cycle
Time
Feature 3
:60
End
IntelliFlo VF Installation and User's Guide
35