Start Up; Stopping; Counter Function - Zummo Z14 Manual Del Usuario

4

START UP

•
Select the correct set of Cups, Balls and Fruit Selector according to the size of the fruit to
be squeezed. See Machine Accessories section in this manual.
•
Fit the rubber rings to the Blade, according to the set of Cups and Balls previously selected
according to figs. 20 -21 – 22.
•
Once the machine is switched on, the display will show either a number between 1 and 50
or the letter C. The number indicates the quantity of fruits to be squeezed, while the letter C
sets the machine to squeeze continuously for approximately 30 minutes.
•
To set the number of oranges to squeeze, press the SELECT button repeatedly to increase
the number (from 1 to 50, followed by the letter C; 1,2,3,..........48,49,50,C,1,2,3.....).
Alternatively, press and hold the SELECT button for 2 seconds and the number will
decrease. Continue until you visualize the wanted number.
•
The selected number will be stored on the display after the first complete squeeze cycle is
finished. The number will be stored even if the machine is switched off. You may change
the number repeating the complete number selection process.
•
Press the ON button to start squeezing. Druing the process, the display will show the
remaining amount of fruits to be squeezed. If you wish to repeat the process, simply press
ON. To stop the process, press the STOP button.
•
ATTENTION!!!: Do NOT place your hand into the basket while the machine is operating
(Fig.23).
5

STOPPING

To stop the machine when is operation, press the Stop button. The display will show a timer
and the message Stop. The machine will stop once the Cups have reached the vertical
position. Once the machine completely stops, the display will show again the number of fruits to
squeeze.
6

COUNTER FUNCTION

The display stores the total number of cycles* completed. To visualize the figure,
Being the machine stopped and in stand-by, press the STOP button
The figure will appear on the display for a few seconds.
Bear in mind that all machines show a minimum of 400 to 500 cycles completed for quality
control testing.
*(cycle = complete set of movements to squeeze a piece of fruit)
16
COUNTER