9
MACHINE CLEANING
The machine squeezing area and parts must be cleaned daily.
If the machine is in operation, stop it always using the Programmer StoP bottom. Never
attempt to stop the machine using the main switch. Failure to follow this recommendation
will cause the machine to stop in a position that impedes cleaning; possibly leading to
breakage of parts due to poor handling.
Disconnect the machine using the power switch. (Fig. 3)
Remove the Front Cover and wash it using a damp cloth. ATTENTION!: NEVER use
products that may scratch it).
Remove the Filter tray to get access to the Juicetray Fastening nuts.
Juicetray and Blade are removed by unscrewing the fastening nuts and pulling outwards
horizontally.
Unscrew the Balls inside the Juicetray (Fig. 5). There is one washer underneath each Ball.
Be careful not to lose them! You may use a dishwasher to wash Juicetray, Filter, Filter
Tray and Blade. TAKE EXTRA CARE WITH THE BLADE (Fig. 12) since it is very sharp and
may cause injuries.
Remove the Cups unscrewing the Fastening Nuts, and wash them.
Remove and wash both Plastic Bins and the Bins Base and wash them.
Once all plastic parts have been removed, clean the machine steel front.
Assembly
After cleaning the whole unit, it is re-assembled as follows:
Fit the washers on the Juicetray and screw the Balls, making sure they are properly
tightened.
Check that the Blade Peel Extracting Bands are correctly fitted in the Blade (Fig. 10 y 11).
Insert the Blade inside the Juicetray.
Assemble both Juicetray and Blade in the machine's three shafts simultaneously. Never fit
the Blade on the Juicetray afterwards!! To introduce the Blade into the Blade shaft,
slightly press down the Blade push it into the shaft. ATTENTION!!! Never press down
the metal part of the Blade.
Fit the Cups on the machine front shafts and tighten the Fastening Nuts.
Fit the Front Cover in place by fitting its clasps into the slots. Make sure that the clasps fit
correctly into the slots. You will hear a small click.
Put the Plastic Bins Base and the Plastic Bins in place.
Before operating the machine, make sure that:
Juicetray and Blade are properly fitted in place.
Fastening Nuts are properly tightened.
The correct set of squeezing parts (Balls, Cups and Fruit Selector) are fitted. (see
"Accessories" in this manual).
If Blade, Juicetray, Balls or Cups are not correctly assembled, serious damage may be caused
to these parts or to the interior components of the machine.
18
(Operator faults not covered by the guarantee)