Parts Counting - Adam Equipment Nimbus NBL Serie Manual De Instrucciones

10.4.1

Parts Counting

This allows the user to weigh a sample of parts to compute an average unit weight and
then determine the number of items being weighed by dividing the net weight by the unit
weight value. The result is always a whole number of parts.
The balance will have a pre-set number of parts to be used as a sample. These values are
10, 25, 50 or 100 items.
Parts
Press [Mode] and cycle through the available options until the " " symbol is displayed.
Now enter parts counting mode by pressing [Setup].
PCS
Press the [Up] or [Down] key to select the sample size, " XX " (where XX=10, 25,
50, 100) then press [Setup] to confirm.
When " XX PCS " is shown, place XX number of items on the pan and press [Setup] to
compute the average piece weight. Display will indicate the total weight in the last selected
unit and then show "XX PCS " sounding a beep. The " Parts " symbol will still be shown at the
top of the display to indicate that the balance is in the parts counting mode
Remove the sample and display will show " PCS ".
Place an unknown quantity of parts on the pan. The balance will then compute the number
of parts based on the average piece weight. The display will show the result in number of
PCS
pieces. This will be an integer value in the format "XX ".
To count another item press [Mode] and continue as before.
Checks will be made to determine that the weight of the reference parts is large enough for
reasonably accurate counting (the weight of each piece must be > 1 division of the
balance).
To return to normal weighing, press one of the [0/T] keys.
23
© Adam Equipment Company 2017