Percentage Weighing - Adam Equipment Nimbus NBL Serie Manual De Instrucciones

Ocultar thumbs Ver también para Nimbus NBL Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

10.4.2

Percentage Weighing

Percent weighing will be done by defining a certain weight to be 100%. The weight to be
used can either be entered by the user or taken from a sample
Press [Mode] and then the [Up] or [Down] key until the "
enter percent weighing mode by pressing [Setup].
Display will show, "
Press the [Up] or [Down] keys to toggle between the two methods and press [Setup] to
select the desired method.
10.4.2.1
Sample method:
%
When "
" is displayed, press [Setup].
When "" followed by 
[Setup] to set this weight to be 100%. The display will show "" and the sample
weight in the last selected unit. After a short pause, "
be shown on the top of the display to indicate that the balance is in the percent weighing
mode
Remove the sample and ".
Now place an unknown sample on the pan to display the percentage weight relative to the
original sample.
To set another weight as 100%, press [Mode] and repeat as before.
10.4.2.2
Manual method:
To manually enter a value to be set as 100%, when " 
The display will briefly show "" followed by a weight value in the unit last used in the
weighing mode.
Change the displayed weight to the required sample weight using the direction keys and
numeric entry method and press [Setup] to enter the value. The display will now return to
zero.
Now place unknown samples on the pan to display the percentage weight relative to the
set sample weight.
To repeat percent weighing with another sample press [Mode] and continue as before, or
to return to normal weighing mode, press [Mode] followed by [0/T].
NOTE: Percentage will be initially displayed to the maximum number of decimal places
based on the resolution of the balance. To increase or decrease by one decimal place,
press the [Up] or [Down] key respectively.
© Adam Equipment Company 2017
%
" (sample method) or "
%
" is shown, carefully add the sample to the pan. Now press
%
" will be displayed
Percent
" symbol is displayed. Now
%
" (manual weight method).
%
" will be displayed. "
" is displayed, press [Setup].
%
24
Percent
" will

Publicidad

Tabla de contenido
loading

Tabla de contenido