Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
GENERAL
• See Dimensions
and Clearances
in this section
for
all rough-in
and spacing
dimensions.
These
dimen-
sions must be met for safe use of your range. The
location of the electrical
outlet and pipe opening
(see
Gas
Pipe
and
Electric
Outlet
Locations)
may be
adjusted
to meet specific
requirements_
• The range may be placed
with 0" (0 cm) clearance
(flush) at the back wall and side walls of the range.
LOCATION
Do not locate
the range where
it may be subject
to
strong drafts. Any openings
in the floor or wall behind
the range should
be sealed.. Make sure the openings
around
the base of the range that supply fresh air for
combustion
and ventilation
are not obstructed
by car-
peting or woodwork.
PROTECT YOUR FLOOR
Your range, like many other household
items, is heavy
and can settle into soft floor coverings
such as cush-
ioned vinyl or carpeting°
Use care when
moving
the
range on this type of flooring°
It is recommended
that
the following
simple
and inexpensive
instructions
be
followed
to protect your floor.
The range should
be installed
on a sheet of plywood
(or similar
material).
When the floor covering
ends at
the front of the range, the area that the range will rest
on should
be built up with plywood
to the same level
or higher
than the floor covering°
This will allow the
range to be moved for cleaning
or servicing.
MODEL AND SERIAL NUMBER LOCATION
Depending
on your range,
you'll find the model and
serial
numbers
on a label on the front frame
of the
range,
behind
the storage
drawer,
broiler
drawer
or
kick panel.
TOOLS YOU WILL NEED
• Phillips and fiat-blade
screwdrivers
• Pencil and ruler
• Two pipe wrenches
(one for backup)
• 1%" open-end
or adjustable
wrench
, Nut drivers or wrenches:
3/t6"
and 1/4"
ADDITIONAL MATERIALS YOU MAY NEED
• Gas line shut-off valve
° Pipe joint sealant
or UL-approved
pipe thread
tape
with Teflon*
that resists
action
of natural
and LP
gases
• Flexible
metal
appliance
connector
(1/2"
I.Do), A
5-foot
(1.5 m) length
is recommended
for ease of
installation
but other lengths
are acceptable.
Never
use an old connector
when installing
a new range.
• Flare union adapter
for connection
to gas supply line
(3/4" or 1/2" NPT x 1/2" I.D.)
= Flare union adapter for connection
to pressure
regu-
lator on range (1/2" NPT x 1/2" I.D.)
•Teflon: Registered trademark of DuPont
PREPARATION
, Remove
all tape and packaging.
Lift up the cooktop
(on models with dual burners)
and remove any pack-
ing material under it. Make sure the dual burners
are
properly
seated and level.
° Remove
plastic film that covers
some chrome
parts
(around oven door, side trim).
o Take the accessory
pack out of the oven
• Check
to be sure that no range
parts
have
come
loose during shipping
34
Publicidad
Tabla de contenido
