Fcc Conformance For Rfid; Product Overview - HACH LANGE PAT700 Manual Básico Del Usuario

These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to
correct the interference at their expense. The following techniques can be used to reduce
interference problems:
1. Disconnect the equipment from its power source to verify that it is or is not the source of the
interference.
2. If the equipment is connected to the same outlet as the device experiencing interference, connect
the equipment to a different outlet.
3. Move the equipment away from the device receiving the interference.
4. Reposition the receiving antenna for the device receiving the interference.
5. Try combinations of the above.

FCC conformance for RFID

This instrument may contain a registered radio frequency identification device (RFID). Refer to
Table 1.
Parameter
FCC identification number (FCC ID)
IC
For Japan
Frequency
RF output power

Product overview

Chemical or biological hazards. If this instrument is used to monitor a treatment process and/or
chemical feed system for which there are regulatory limits and monitoring requirements related to
public health, public safety, food or beverage manufacture or processing, it is the responsibility of the
user of this instrument to know and abide by any applicable regulation and to have sufficient and
appropriate mechanisms in place for compliance with applicable regulations in the event of malfunction
of the instrument.
This analyzer uses UV light to oxidize water samples for TOC analysis in pure and ultra-pure water
process applications. The analyzer is capable of compliance to 21 CFR Part 11 with password
protection and an audit trail of all user actions.
For power and data collection, the analyzer connects to the facility systems through quick-connect
wiring connections. Some analyzers have conduit openings instead of quick-connect wiring
connections with internal connector blocks for conduit wiring connections.
The analyzer has an OASIS bottle bay to measure individual grab samples or do a
calibration/validation. Bottle information is read automatically with the radio frequency identification
device (RFID) wireless system and RFID tags on the bottles
expanded user manual available on the manufacturer's website.
*
Not all models include the RFID wireless system
6 English
Table 1 Registration information
Value
VICPAT700TOC
6149A-PT700TOC
13.56 MHz to ±7 kHz
<180 mW
D A N G E R
*
. For more information, refer to the