Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Complete the installation
1. Adjust height of range and level by rotating the ad-
justable leg supports on the bottom of the range,
using 1-4" (32 mm) wrench.
2. Locate bracket position as shown below.
3. Secure bracket with 2 screws to the loor or to
the wall. Depending on loor or wall material use
wood or anchorless concrete screws (included).
Concrete screws require a 3/16" masonry bit.
Service
To reach a service representative, see the contact
information at the front of the manual. Please be
prepared to provide the information from the data
tag on the appliance.
4. Move range close enough to the opening to plug
into the receptacle.
5. Slide range into position ensuring that the left
back leg slides under the antitip bracket. Range
will sit ¾" (19 mm) away from back wall when
properly installed.
6. Carefully tip range forward to ensure that the anti
tip bracket engages the range back brace and
prevents tip-over.
7. Turn on electrical power. Check range for proper
operation as described in Use and Care Manual.
CAUTION
If the display lashes and beeps, the polarity of
the wiring may be reversed. Reversed polarity can
damage the range and can result in electrical shock
hazard. Immediately switch off power at the breaker
and return to Step 5-Connect Electric.
Data Tag
The data tag is on the appliance frame near the
drawer. Open the drawer to view it.
Data Plate
11
Publicidad
Tabla de contenido
