Bosch 40 Instrucciones De Instalación página 9

Three Wire Range Cord Connection
The Four Wire Connection (above) is preferred, but
where local codes and ordinances permit grounding
through neutral and where conversion to four wire is
impractical, the unit may be connected to the power
supply via a three wire connection.
1. Disconnect electrical power at breaker box.
2. Remove the terminal block cover to expose the
terminal block.
3. Remove top nut, star washer, and round washer
from each post.
Note: DO NOT remove last round washer, last nut or
internal wiring leads.
4. Attach white wire, round washer, star washer and
nut IN THIS ORDER on top of ground strap on
center post.
5. Attach red wire, round washer, star washer and
nut IN THIS ORDER to left post.
6. Attach black wire, round washer, star washer and
nut IN THIS ORDER to right post.
ground strap
red
7. Tighten all connections securely and replace ter-
minal block cover.
black
white
green ground screw
8. Properly secure strain relief (see previous section).
Note: DO NOT plug in range at this time.
Four Wire Flexible Conduit Connection
1. Disconnect electrical power at the breaker box.
2. Remove the terminal block cover to expose the
terminal block.
3. Remove the top nut, star washer, and round
washer from each post.
Note: DO NOT remove last round washer, last nut or
internal wire leads.
4. Remove screw from bottom end of ground strap.
5. Remove ground strap from center post. Discard.
6. Attach one terminal lug (packaged with this
manual) through hole below terminal block with
ground screw.
7. Place one terminal lug (packaged with this man-
ual) on each post. Replace the star washer and
round washer and secure with 20" pounds of
torque.
8. Strip 8" (9.5 mm) of insulation from the end of
the wire.
9. Insert the insulated grounding wire into the lug
below the terminal block.
10. Insert stripped end of white wire into the center
lug. Secure the clampingscrew.
lug
wire
3/8 "
clamping screw
9