Technical Data; Power Requirements - Truper DES-440T Manual Del Usuario

Technical Data

Code
Description
Voltage
Frequency
Current
Power
Speed
Cutting capacity
Cutting string diameter
Duty cycle
Insulation
WARNING
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
WARNING

Power Requirements

Before using the power cord or an additional flexible cord, verify that there are not present signs of damage or abuse.
If the cord gets damaged during its use, disconnect the cord from the power source immediately. DON´T TOUCH THE
POWER CORD BEFORE DISCONNECTING IT FROM THE POWER SOURCE. Don´t use the tool if the power cord is
damaged or abused.
WARNING Tools with double insulation and reinforced insulation are
equipped with a polarized plug (one prong is wider than the other). This plug will
only fit in the right way into a polarized outlet. If the plug cannot be introduced
into the outlet, reverse the plug. If it still doesn't fit, call a qualified electrician to
install for you a polarized outlet. Do not alter the plug in any way. Both insulation
types eliminate the need of both a grounded third power cord with three
prongs or a grounded power connection.
WARNING
When using an extension cable, verify the gauge is enough for the power that your product needs. A lower
gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The following table shows the right
size to use depending on cable's length and the ampere capability shown in the tool's nameplate. When in doubt use the
next higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
WARNING When operating power tools outdoors, use a
extension cable labeled "For Outdoors Use". These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
30 minutes work per 15 minutes idle. Maximum three hours daily.
Class II
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
Before gaining access to the terminals all power sources should be disconnected.
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
DES-440T
10975
Electric string trimmer/edger
127 V
60 Hz
3,54 A
0.6 Hp
10 300 RPM
13"
0.062"
IP Grade
Build Quality: Double Insulation.
Thermal insulation on motor winding: Class E
Authorized Service Center.
Extension gauge
from 5.9' to 49.2'
18 AWG( * )
16 AWG
14 AWG
8 AWG
grounded
IP20
| higher than 49.2'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3