Replacing Liner In Torch Neck - Abicor Binzel PP Instructivo De Servicio

8 Maintenance and cleaning

8.2 Replacing liner in torch neck

1 Torch neck
2 Nut
3 Inlet nozzle
Fig. 7 Replacing liner in torch neck
1 Remove torch neck (1) from torch seat (7) by unscrewing the nut (2).
2 Lift off clamping cap (4) and swing out seat clamp (6) laterally.
3 Unscrew counter nut (5) from the inlet nozzle (3).
4 Remove inlet nozzle (3) from PP body toward the front by unscrewing it and replace it.
NOTICE
• In the case of bent torch necks, a liner (plastic) (8) (outer diameter D = 4.0 mm) must be
mounted additionally between inlet nozzle (3) and contact tip.
• The actual length of the liner (plastic) (8) must be adjusted, depending on the
application.
5 Screw in inlet nozzle (3) until a short distance in front of the wire feed roll and secure it in
this position with the counter nut (5).
6 The inlet nozzle (3) is mounted in reverse order.
EN - 16
1 2
8
4 Clamping cap
5 Counter nut M3
6 Seat clamp
3
7
7
8
4
5
6
Torch seat
Liner (plastic)
BAL.0212.0 • 2018-07-16
PP