Unit Installation; General Duct Work Installation; Process Air Inlet; Wet Air Outlet - DST DR-40 T10 Manual Del Usuario

4 INSTALLATION

4.1 UNIT INSTALLATION

Use the installation guidelines as a reference only.

4.2 GENERAL DUCT WORK INSTALLATION

for more information.
•
•
•
•
• Install dry air out duct/channel at a high level.
•
• Allow wet air to disperse freely when exiting the duct.
•
•
•
•

4.3 PROCESS AIR INLET

Units labelled with "Process air inlet" on both inlet spigots, use the smaller air inlet spigot as the regeneration air inlet.

4.4 WET AIR OUTLET

Install a damper on wet air outlet to adjust the electric consumption during free blowing operation. Other models may require a damper to prevent from overloading during
free blowing operation.
At delivery, a throttle is included. This is not installed.
See heater current in
DR-40 T10, T16 EN.03
.
A
11
EN
Seibu Giken DST