Evolution R255 SMS Instrucciones Originales página 10

• Never carry the mitre saw by the power cord.
Carrying the mitre saw by the power cord could
cause damage to the insulation or the wire
connections resulting in electric shock or fire.
• Before moving the mitre saw tighten the
mitre and bevel locking screws and the
sliding carriage locking screw to guard
against sudden unexpected movement.
• Lock the cutting head in its lowest position.
Ensure that the cutting head locking pin is
completely engaged in its socket.
WARNING: Do not use the blade guard as
a 'lifting point' . The power cord must be
removed from the power supply before
attempting to move the machine.
• Lock the cutting head in the down position
using the cutting head locking pin.
• Loosen the Mitre Angle locking screw. Turn
the table to either of its maximum settings.
• Lock the table in position using the
locking screw.
• Wrap the cable around the cable guide.
GETTING STARTED -
(4.1)
UNPACKING
WARNING: Due to the power input of this
product on start up, voltage drops may occur
and this can influence other equipment (e.g.
dimming lights). So for technical reasons we
advise, if the mains-impedance is Zmax<0.318
Ohm, these disturbances are not expected.
If you require further clarification, you may
contact your local power supply authority.
Caution: This packaging contains sharp
objects. Take care when unpacking. This
machine could require two persons to lift,
assemble and move this machine. Remove
the machine, together with the accessories
supplied from the packaging.
Check carefully to ensure that the machine
is in good condition and account for all the
accessories listed in this manual. Also make
sure that all the accessories are complete.
If any parts are found to be missing, the machine
and its accessories should be returned together
in their original packaging to the retailer.
Do not throw the packaging away; keep it safe
throughout the warranty period. Dispose of
www.evolutionpowertools.com
the packaging in an environmentally
responsible manner. Recycle if possible. Do not
let children play with empty plastic bags due to
the risk of suffocation.
SERIAL NO. / BATCH CODE
The serial number can be found on the motor
housing of the machine.
For instructions on how to identify the batch
code, please contact the Evolution Power
Tools helpline or go to:
www.evolutionpowertools.com
ADDITIONAL ACCESSORIES
(4.3)
In addition to the standard items supplied
with this machine the following accessories
are also available from the Evolution online
shop at www.evolutionpowertools.com or
from your local retailer.
(4.4)
Description
RAGE Multi-Materal
TCT Blade
Dust Bag
Front Clamp
10
Part No
RAGEBLADE255MULTI
030-0309
040-0038R