Programming Of Steering-Wheel Commands And Car-Radio; Memorizing The Keys - Phonocar 04083 Manual De Instrucciones

Programming of steering-wheel commands and car-radio

MEMORIZING THE KEYS

After having effected the connections, and without introducing the Jack of the steering-wheel commands on the
back of the car-radio, turn the ignition-key, so that the LED will turn on and flash red.
To correctly memorize the functions onto the keys of the steering-wheel commands, a programming-procedure
needs to be effected, starting from function 1 (VOL-), all through the stated sequence indicated on the table.
Press steering-wheel command VOL- so that the LED will turn on and flash red, meaning that the memorization has
taken place. This procedure is valid for all other functions: 2 (VOL+), 3 (SEEK-), 4 (SEEK+) etc.
ATTENTION:
The central-box is capable of executing 10 functions (12 functions for models from 2020).
ALL of these functions need to be either activated or deactivated.
Activation is made by pressing the keys on the steering-wheel.
Deactivation is made by pressing the PRG-key, located on the central-box.
Once the steering-wheel commands have been determined, the LED on the Interface will start flashing green.
Sequence
for
Function
Clarion
Memorization
1
2
3
4
5 FUNC
6 MUTE
7 BAND
8 DISP
9 TA
10 AF
*Only for VM057 ( JACK3,5)
FUNCTIONS PROGRAMMING TABLE
Kenwood JVC
SRC SOURCE
MUTE MUTE
UP UP
DOWN DOWN
SPEECH
CAR-RADIO
Pioneer Sony
VOLUME -
VOLUME +
SEEK -
SEEK +
MODE SOURCE
MUTE MUTE
UP UP
DOWN DOWN
24
Alpine Blaunpunkt Phonocar
SOURCE SOURCE
MUTE MUTE
UP
DOWN
UP OK
DOWN NO
EN
MODE
MUTE
PLAY/
PAUSE
BAND
*
*