Using Internal Water Dispenser; Dispensing Water - Grundig GQN21220X Manual De Usuario

5.17 Using internal
water dispenser
(in some models)
After connecting the refrigerator
to a water source or replacing the
water filter, flush the water system.
Use a sturdy container to depress
and hold the water dispenser lever
for 5 seconds, then release it for 5
seconds. Repeat until water begins
to flow. Once water begins to flow,
continue depressing and releasing
the dispenser paddle (5 seconds on,
5 seconds off) until a total of 4 gal.
(15L) has been dispensed. This will
flush air from the filter and water
dispensing system, and prepare
the water filter for use. Additional
flushing may be required in some
households. As air is cleared from
the system, water may spurt out of
the dispenser.
Allow 24 hours for the refrigerator
to cool down and chill water.
Dispense enough water every week
to maintain a fresh supply.
After 5 minutes of
continuous dispensing,
the dispenser will stop
C
dispensing water to avoid
flooding. To continue
dispensing, press the
dispenser paddle again.
32

5.18 Dispensing Water

Hold a container under the dispenser
spout while pressing the dispenser
pad.
Release the dispenser pad to stop
dispensing.
C
It is normal for the first few
glasses of water taken from
the dispenser to be warm.
C
If the water dispenser is
not used for a long period
of time, dispose of first few
glasses of water to obtain
fresh water.
During initial use, you will have to
wait approximately 24 hours for the
water to cool down.
Take out the glass a little while after
you pull the trigger.