Bevelled Cutting - Super Ego 189 Manual De Usuario

7. OPERATING CONTROLS AND ADJUSTMENTS
Elements of Fig. 15 - 18
A: "Half a thread" turned
B: Screw
C: Crank handle removed
D: Opening for the piece to be cut
E: Lathe in contact with the piece
F: Piece to be cut
G: "Half a thread" turned
You do not need to turn the screw handle when the
half-nut is in the raised position. The screw handle can
be rapidly pulled out or pushed in.
F
G
Fig. 18
NOTE
41

7.6 BEVELLED CUTTING

The band saw arc can be rotated for bevelled cuts (0° to
45°).
Raise the handle (A) - (Fig. 19) and turn it in the direction
shown to loosen it.
Rotate the band saw arch to the desired angle on the
scale (B) - (Fig. 20). Adjustable stops (C) for 90° and 45°
enable a quick set-up (Fig. 20).
C
Elements of Fig. 19 - 20
A: Handle
B: Turning scale of the bevelled angle
C: Adjustable end stops (90º, 45º)
A
Fig. 19
B
C
Fig. 20