Britax Child Safety, Inc.
Certification
This Restraint is Certified For Use in Motor Vehicles and
Aircraft�
Motor Vehicles
This child seat system conforms to all applicable Federal
motor vehicle safety standards (FMVSS 213).
Aircraft
This child seat is certified for aircraft use. The
FAA recommends that a child weighing up to
40 lbs (18 kg) use a certified, harnessed child
seat while traveling on an aircraft. Contact the
airline about their policy prior to traveling.
For rear-facing aircraft installation:
1. Recline this child seat (see page 25) and place rear-
facing on the aircraft seat.
2. Slide the aircraft lap belt into the
rear-facing belt slots over the cover
with the CLICKTIGHT in the closed
position.
3. Ensure the lap belt is not twisted,
buckle, and remove all slack.
For forward-facing aircraft
installation:
1. Place this child seat forward-facing on the aircraft seat in
the upright position.
2. Slide the aircraft lap belt into the
forward-facing belt slots under the
cover with the CLICKTIGHT in the
closed position.
3. Ensure the lap belt is not twisted,
buckle, and remove all slack.
NOTE: For further instructions on
securing your child and adjusting fit
see page 20.
– Install your child seat in a window seat to avoid
blocking the aisle.
– If the aircraft lap belt is too short, ask a flight attendant
for a belt extender.
– Your child may experience discomfort if the buckle
is located in the seating area of the child seat after
installation.
– Inflatable aircraft lap belts are not compatible with this
child seat.
– This seat may not fit all aircraft. Contact your airline
prior to travel to verify fit.
6