Uninstalling The Seat - Britax MARATHON CLICKTIGHT Guia Del Usuario

Britax Child Safety, Inc.
Overhang
It is important that the base of the child seat rests completely
flat on the vehicle seat with no side overhang. As seen in the
illustration, it is permissible to allow up to 3 in. (7.6 cm) of the
base to hang over the
front edge of the vehicle
seat. If the vehicle seat
does not allow enough
of the child seat base to
make contact, adjust the
recline angle to a more
upright position. Not
doing so could cause the
child seat to not perform
as intended.
In some cases, the vehicle head
restraint can prevent the child
seat head pad from being raised
high enough to properly adjust the
harness for the fit of your child when
using a forward facing reclined
position. DO NOT force the child
seat head pad past the vehicle head
restraint. Doing so could cause the child seat not to
perform as intended. If the location of the vehicle head
restraint interferes with the child seat head pad, raise
or remove the vehicle head restraint. If the vehicle head
restraint cannot be removed, move the child seat to the
upright position or try a different seating location.

Uninstalling the Seat

1. Unbuckle the vehicle seat
belt.
NOTE: For car seats
installed with lower
connectors, see page 29.
2. Open the CLICKTIGHT.
26
Acceptable
Forward-Facing
3"
Acceptable
Rear-Facing
3"